List Archives

Tue, 14 Jan 2003 17:42:01 -0000

This is a multi-part message in MIME format.

------=_NextPart_000_0002_01C2BBF4.3E6E5E30
Content-Type: text/plain;
	charset="US-ASCII"
Content-Transfer-Encoding: 7bit

Wonderful!!!
Nick

Dr NJD Macartney FRCA
ICU, Chase Farm Hospital, Enfield, Middlesex
EN2 8JL
+447831 630068 Mobile
+4420 89675955 ICU

  -----Original Message-----
  From: trauma-list-admin@trauma.org [mailto:trauma-list-admin@trauma.org]On
Behalf Of Dr. Bryan Bledsoe
  Sent: 14 January 2003 16:30
  To: trauma-list@trauma.org
  Subject: RE: Please remove me from your list.

  First, ask your Internet Provider to mail you an Unsubscribing
  Kit. Then follow these directions. The kit will most likely be
  the standard no-fault type. Depending on requirements, System
  A and/or System B can be used. When operating System A,
  depress lever and a plastic dalkron unsubscriber will be
  dispensed through the slot immediately underneath. When you
  have fastened the adhesive lip, attach connection marked by
  the large "X" outlet hose. Twist the silver- coloured ring one
  inch below the connection point until you feel it lock.

  The kit is now ready for use. The Cin-Eliminator is activated
  by the small switch on the lip. When securing, twist the ring
  back to its initial condition, so that the two orange lines
  meet. Disconnect.

  Place the dalkron unsubscriber in the vacuum receptacle to the
  rear. Activate by pressing the blue button.

  The controls for System B are located on the opposite side.
  The red release switch places the Cin-Eliminator into
  position; it can be adjusted manually up or down by pressing
  the blue manual release button. The opening is self-
  adjusting. To secure after use, press the green button, which
  simultaneously activates the evaporator and returns the Cin-
  Eliminator to its storage position.

  You may log off if the green exit light is on over the
  evaporator. If the red light is illuminated, one of the Cin-
  Eliminator requirements has not been properly implemented.
  Press the "List Guy" call button on the right of the
  evaporator. He will secure all facilities from his control
  panel.

  To use the Auto-Unsub, first undress and place all your
  clothes in the clothes rack. Put on the velcro slippers
  located in the cabinet immediately below. Enter the shower,
  taking the entire kit with you. On the control panel to your
  upper right upon entering you will see a "Shower seal" button.
  Press to activate. A green light will then be illuminated
  immediately below. On the intensity knob, select the desired
  setting. Now depress the Auto-Unsub activation lever. Bathe
  normally.

  The Auto-Unsub will automatically go off after three minutes
  unless you activate the "Manual off" override switch by
  flipping it up. When you are ready to leave, press the blue
  "Shower seal" release button. The door will open and you may
  leave. Please remove the velcro slippers and place them in
  their container.

  If you prefer the ultrasonic log-off mode, press the indicated
  blue button. When the twin panels open, pull forward by rings
  A & B. The knob to the left, just below the blue light, has
  three settings, low, medium or high. For normal use, the
  medium setting is suggested.

  After these settings have been made, you can activate the
  device by switching to the "ON" position the clearly marked
  red switch. If during the unsubscribing operation you wish to
  change the settings, place the "manual off" override switch in
  the "OFF" position. You may now make the change and repeat the
  cycle. When the green exit light goes on, you may log off and
  have lunch. Please close the door behind you

  ----Original Message-----
  From: trauma-list-admin@trauma.org [mailto:trauma-list-admin@trauma.org]
On Behalf Of Martin Cross
  Sent: Tuesday, January 14, 2003 8:48 AM
  To: trauma-list@trauma.org
  Subject: Please remove me from your list.

   To Many e-mails Remove me from the list

----------------------------------------------------------------------------
--

  With Yahoo! Mail you can get a bigger mailbox -- choose a size that fits
your needs

------=_NextPart_000_0002_01C2BBF4.3E6E5E30
Content-Type: text/html;
	charset="US-ASCII"
Content-Transfer-Encoding: quoted-printable

<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META http-equiv=3DContent-Type content=3D"text/html; =
charset=3Dus-ascii">
<META content=3D"MSHTML 6.00.2800.1126" name=3DGENERATOR>
<STYLE>@font-face {
	font-family: Tahoma;
}
@page Section1 {size: 8.5in 11.0in; margin: 1.0in 1.25in 1.0in 1.25in; }
P.MsoNormal {
	FONT-SIZE: 12pt; MARGIN: 0in 0in 0pt; FONT-FAMILY: "Times New Roman"
}
LI.MsoNormal {
	FONT-SIZE: 12pt; MARGIN: 0in 0in 0pt; FONT-FAMILY: "Times New Roman"
}
DIV.MsoNormal {
	FONT-SIZE: 12pt; MARGIN: 0in 0in 0pt; FONT-FAMILY: "Times New Roman"
}
A:link {
	COLOR: blue; TEXT-DECORATION: underline
}
SPAN.MsoHyperlink {
	COLOR: blue; TEXT-DECORATION: underline
}
A:visited {
	COLOR: blue; TEXT-DECORATION: underline
}
SPAN.MsoHyperlinkFollowed {
	COLOR: blue; TEXT-DECORATION: underline
}
P {
	FONT-SIZE: 12pt; MARGIN-LEFT: 0in; MARGIN-RIGHT: 0in; FONT-FAMILY: =
"Times New Roman"
}
SPAN.EmailStyle18 {
	COLOR: navy; FONT-FAMILY: Arial
}
DIV.Section1 {
	page: Section1
}
</STYLE>
</HEAD>
<BODY lang=3DEN-US vLink=3Dblue link=3Dblue>
<DIV><SPAN class=3D172334117-14012003><FONT face=3DArial color=3D#0000ff =

size=3D2>Wonderful!!!</FONT></SPAN></DIV>
<DIV><SPAN class=3D172334117-14012003><FONT face=3DArial color=3D#0000ff =

size=3D2>Nick</DIV>
<DIV>&nbsp;</DIV>
Dr NJD Macartney FRCA ICU, Chase Farm Hospital, =
Enfield,=20
Middlesex EN2 8JL +447831 630068 Mobile +4420 89675955 ICU =

<BLOCKQUOTE dir=3Dltr=20
style=3D"PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #0000ff 2px =
solid; MARGIN-RIGHT: 0px">
 <DIV class=3DOutlookMessageHeader dir=3Dltr align=3Dleft>-----Original Message----- From: =
trauma-list-admin@trauma.org=20
 [mailto:trauma-list-admin@trauma.org]On Behalf Of Dr. Bryan=20
 Bledsoe Sent: 14 January 2003 16:30 To:=20
 trauma-list@trauma.org Subject: RE: Please remove me from =
your=20
 list. </DIV>
 <DIV class=3DSection1>
 <SPAN=20
 style=3D"FONT-SIZE: 12pt">First, ask your Internet Provider to mail =
you an=20
 Unsubscribing Kit. Then follow these directions. The kit will most =
likely=20
 be the standard no-fault type. Depending on requirements, =
System A=20
 and/or System B can be used. When operating System A, depress lever =
and a=20
 plastic dalkron unsubscriber will be dispensed through the slot =
immediately=20
 underneath. When you have fastened the adhesive lip, attach =
connection=20
 marked by the large "X" outlet hose. Twist the silver- coloured =
ring=20
 one inch below the connection point until you feel it =
lock. The kit=20
 is now ready for use. The Cin-Eliminator is activated by the small =
switch=20
 on the lip. When securing, twist the ring back to its initial =
condition, so=20
 that the two orange lines meet. Disconnect. Place the =
dalkron=20
 unsubscriber in the vacuum receptacle to the rear. Activate by =
pressing the=20
 blue button. The controls for System B are located on the =
opposite=20
 side. The red release switch places the Cin-Eliminator =
into position; it=20
 can be adjusted manually up or down by pressing the blue manual =
release=20
 button. The opening is self- adjusting. To secure after use, press =
the=20
 green button, which simultaneously activates the evaporator and =
returns the=20
 Cin- Eliminator to its storage position. 
 <SPAN=20
 style=3D"FONT-SIZE: 12pt">You may log off if the green exit light is =
on over=20
 the evaporator. If the red light is illuminated, one of the=20
 Cin- Eliminator requirements has not been properly =
implemented. Press=20
 the "List Guy" call button on the right of the evaporator. He will =
secure=20
 all facilities from his control panel. To use the =
Auto-Unsub, first=20
 undress and place all your clothes in the clothes rack. Put on the =
velcro=20
 slippers located in the cabinet immediately below. Enter the=20
 shower, taking the entire kit with you. On the control panel to=20
 your upper right upon entering you will see a "Shower seal"=20
 button. Press to activate. A green light will then be=20
 illuminated immediately below. On the intensity knob, select the=20
 desired setting. Now depress the Auto-Unsub activation lever.=20
 Bathe normally. The Auto-Unsub will automatically go off =
after three=20
 minutes unless you activate the "Manual off" override switch =
by flipping=20
 it up. When you are ready to leave, press the blue "Shower seal" =
release=20
 button. The door will open and you may leave. Please remove the =
velcro=20
 slippers and place them in their =
container. 
 <SPAN=20
 style=3D"FONT-SIZE: 12pt">If you prefer the ultrasonic log-off mode, =
press the=20
 indicated blue button. When the twin panels open, pull forward by=20
 rings A &amp; B. The knob to the left, just below the blue light,=20
 has three settings, low, medium or high. For normal use, =
the medium=20
 setting is suggested. After these settings have been made, you =
can=20
 activate the device by switching to the "ON" position the clearly=20
 marked red switch. If during the unsubscribing operation you wish=20
 to change the settings, place the "manual off" override switch =
in the=20
 "OFF" position. You may now make the change and repeat the cycle. =
When the=20
 green exit light goes on, you may log off and have lunch. Please =
close the=20
 door behind you
 <SPAN=20
 style=3D"FONT-SIZE: 10pt; FONT-FAMILY: =
Tahoma">&nbsp;
 <SPAN=20
 style=3D"FONT-SIZE: 10pt; FONT-FAMILY: Tahoma">----Original=20
 Message----- From:=20
 trauma-list-admin@trauma.org [mailto:trauma-list-admin@trauma.org] =
<SPAN=20
 style=3D"FONT-WEIGHT: bold">On Behalf Of Martin =
Cross <SPAN=20
 style=3D"FONT-WEIGHT: bold">Sent: Tuesday, =
January 14,=20
 2003<SPAN=20
 style=3D"FONT-SIZE: 10pt; FONT-FAMILY: Tahoma"> 8:48=20
 AM<SPAN=20
 style=3D"FONT-SIZE: 10pt; FONT-FAMILY: Tahoma"> <SPAN=20
 style=3D"FONT-WEIGHT: bold">To: =
trauma-list@trauma.org <SPAN=20
 style=3D"FONT-WEIGHT: bold">Subject: Please remove me from =
your=20
 list.
 &nbsp;
 <SPAN=20
 style=3D"FONT-SIZE: 12pt">&nbsp;To Many e-mails Remove me from the=20
 list
 <SPAN=20
 style=3D"FONT-SIZE: 12pt">&nbsp;
 <DIV class=3DMsoNormal style=3D"MARGIN-LEFT: 0.5in; TEXT-ALIGN: =
center"=20
 align=3Dcenter><SPAN=20
style=3D"FONT-SIZE: 12pt">
 <HR align=3Dcenter width=3D"100%" SIZE=3D1>
 </DIV>
 <A=20
 =
href=http://www.trauma.org/index.php/community/list/url/http:list.ftech.net/pipermail/trauma-list/2003-January/3D"http://uk.yahoo.com/mail/tagline_xtra/?http://uk.docs.yahoo.com/m=
ail_storage.html"><FONT=20
 face=3DArial size=3D2><SPAN=20
 style=3D"FONT-WEIGHT: bold; FONT-SIZE: 10pt; FONT-FAMILY: Arial">With =
Yahoo!=20
 Mail you can get a bigger mailbox -- choose a size that fits your=20
 =
needs</A></DIV></BLOCKQUOTE></BODY></=
HTML>

------=_NextPart_000_0002_01C2BBF4.3E6E5E30--

List Archives

For your convenience, find the Trauma List Archive Below

Please remove me from your list.